{"id":4260,"date":"2022-04-20T06:43:21","date_gmt":"2022-04-20T06:43:21","guid":{"rendered":"https:\/\/www.svasek.nl\/project\/wave-study-bjornafjorden-floating-bridge\/"},"modified":"2024-02-29T13:20:55","modified_gmt":"2024-02-29T13:20:55","slug":"bjornafjorden-floating-bridge","status":"publish","type":"project","link":"https:\/\/www.svasek.nl\/en\/project\/bjornafjorden-floating-bridge\/","title":{"rendered":"Bj\u00f8rnafjorden floating bridge"},"content":{"rendered":"

The Norwegian Public Roads Administration (NPRA) plans a floating bridge crossing in Bj\u00f8rnafjorden to replace the existing ferries …<\/p>\n","protected":false},"featured_media":5082,"template":"","tags":[],"project_category":[32,23],"class_list":["post-4260","project","type-project","status-publish","has-post-thumbnail","hentry","project_category-hares-en","project_category-waves-en"],"acf":{"download_pdf_button":5078,"download_pdf_button_en":5078,"project_info":{"left":{"diensten":"Wave penetration study to determine wave conditions and phase differences between consecutive bridge pontoons","opdrachtgever":"Statens vegvesen (Norwegian Public Roads Administration)","locatie":"Bj\u00f8rnafjorden, Norway","datum":"2022"},"right":{"google_map":{"address":"499J+83 S\u00f8re \u00d8yane, Norway","lat":60.11833477985967,"lng":5.3802192070312405,"zoom":8,"place_id":"GhIJRv0_mCUPTkARwT6VLliFFUA","city":"S\u00f8re \u00d8yane","state":"Vestland","country":"Norway","country_short":"NO"}}},"content":{"title":"Wave penetration study Norwegian fjord","text":"The Norwegian Public Roads Administration (NPRA) plans a floating bridge crossing in Bj\u00f8rnafjorden to replace the existing ferries. At the planned crossing, the water depth is approximately 550 m, and the width of the fjord is approximately 5 km. These conditions make it impossible to use conventional bridges. Currently, the chosen solution is an anchored curved floating bridge with a cable stayed bridge connected to land on the southern shore. The floating bridge will have 40 pontoons.\r\n\r\nLong-term wave measurements at Bj\u00f8rnafjorden show that wind waves and swell waves occur at the project site. The observed swell waves are generated in the North Sea and North Atlantic Ocean and then propagate into the fjord through the Krossfjord (north) and Selbj\u00f8rnfjord (south). Swell waves are very relevant as they can interact with the bridge and may excite undesirable behaviour on the construction.\r\n\r\nNPRA requested Sva\u0161ek Hydraulics to investigate the behaviour and propagation of the incoming swell waves from the North Sea into the fjord for various wave conditions. Wave height, wave period, wave direction, phase angles and phase differences are requested at all 40 pontoon locations.\r\n\r\nFor this purpose, Sva\u0161ek Hydraulics used the numerical wave model HARES<\/a> to compute the wave penetration into the fjord. All islands and shallow zones in the fjords are included in the model. The computational mesh has a resolution of 8 meters, which amounts to 11 million elements.\r\n\r\nThis study modelled the wave penetration of swell waves from the North Sea to the floating pontoons of the proposed bridge at Bj\u00f8rnafjorden. There are two possible routes for the North Sea waves to reach the bridge location: a northern route via Krossfjord and a southern route via Selbj\u00f8rnfjord. Both routes are modelled separately, which gives insight into both routes' specific contributions to the wave conditions at the pontoon locations.\r\n\r\nFor the northern and southern routes, monochromatic waves were modelled for wave periods between 8 s and 26 s (with a 2 s interval) and wave directions between 240\u00b0N and 275\u00b0N (northern route) and 245\u00b0N and 275\u00b0N (southern route), both with a 5 degrees interval. A unity wave height of 1 m is applied for all wave conditions. The resulting wave heights at the pontoon locations can directly be interpreted as dimensionless wave penetration factors.\r\n\r\nThe bridge pontoons will respond to specific frequencies. Using monochromatic calculations, the phase differences between two consecutive pontoons can be determined for a specific frequency. Applying a total wave spectrum does not provide the necessary insight per frequency.\r\n\r\n\u00a9 Illustration: Statens vegvesen<\/em><\/span>"},"slider":[{"image":5082,"video":""},{"image":5080,"video":""},{"image":5084,"video":""},{"image":4259,"video":""}],"expert_guy":{"left":{"title":"More information?","content":"Please contact Bernard Eikema.","linkedin_link":"https:\/\/www.linkedin.com\/in\/bernard-eikema\/","email":"eikema@svasek.nl"},"right":{"title":"Bernard Eikema","designation":"Project leader","photo":874}},"cta":{"title":"More information about Sva\u0161ek or our expertises?","text":"Please contact us or make an appointment.","link":{"title":"CONTACT US","url":"https:\/\/www.svasek.nl\/en\/contact\/","target":""}},"custom_links":{"linked_url":""},"hide":""},"aioseo_notices":[],"_links":{"self":[{"href":"https:\/\/www.svasek.nl\/en\/wp-json\/wp\/v2\/project\/4260","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/www.svasek.nl\/en\/wp-json\/wp\/v2\/project"}],"about":[{"href":"https:\/\/www.svasek.nl\/en\/wp-json\/wp\/v2\/types\/project"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/www.svasek.nl\/en\/wp-json\/wp\/v2\/media\/5082"}],"wp:attachment":[{"href":"https:\/\/www.svasek.nl\/en\/wp-json\/wp\/v2\/media?parent=4260"}],"wp:term":[{"taxonomy":"post_tag","embeddable":true,"href":"https:\/\/www.svasek.nl\/en\/wp-json\/wp\/v2\/tags?post=4260"},{"taxonomy":"project_category","embeddable":true,"href":"https:\/\/www.svasek.nl\/en\/wp-json\/wp\/v2\/project_category?post=4260"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}